DJI Agras T50 Fly More Combo

In broadacre work, a well-set-up DJI Agras T50 can reach ~21 ha/hour in favourable conditions. Orchard and vineyard jobs are typically lower (around ~4 ha/hour) due to tighter turns, height changes and terrain-follow. Actual output depends on dose rate, swath, speed/height, wind, refill logistics and field layout.

The T50 has a 40 L liquid tank. With the standard dual atomising sprinklers it supports up to ~16 L/min. Adding the optional four-sprinkler kit can raise potential throughput to ~24 L/min (setup- and product-dependent).

Dual atomising sprinklers cover approx. 50–500 µm droplets. Effective swath is typically ~4–11 m at ~3 m AGL, but varies with speed, height, droplet level and product. Set droplet size/height to the label and target canopy to minimise drift.

Yes. The T50 spreading system has a 75 L / 50 kg hopper for dry granules (approx. 0.5–5 mm) with output up to ~108 kg/min, material and settings permitting. Small-gate options support low-rate seeding.

Yes. Reverse Directional Spray lets you apply while reversing at row ends, reducing tight turns and improving headland coverage.

Yes. Front/rear phased-array radar and binocular vision aid obstacle avoidance and slope-aware terrain-follow — ideal for orchards, vineyards and uneven fields. Always survey new blocks and set safe heights and speeds.

T50 uses the DJI RC Plus (7″ high-brightness) running DJI Agriculture software. If you already operate a T25 with RC Plus, you can typically reuse it (ensure firmware and app versions are current).

RTK is recommended for precise boundaries, repeatable lines and accurate headland work. It also helps with route sharing and consistent overlap. Use NTRIP or a compatible RTK base.

Expect ~10–20 minutes per battery depending on payload, rate and wind. For continuous operations, rotate multiple DB1560 batteries with a high-power charger (e.g., C10000) targeting ~9–12 minute turnarounds to match refill stops.

Use a high-power charger on 220–240 V with adequate supply (or a suitable field generator). Keep batteries shaded, observe charging temperature limits, and maintain good ventilation. We can advise on UK-ready chargers, cables and best practice.

Suitable for many agricultural liquids (pesticides, foliar feeds, liquid fertiliser). Always check formulation compatibility and follow the label for droplet size and water volume. Rinse and flush the system after use.

Use the DJI Agriculture app to configure speed, height, swath, droplet level and target L/ha. Calibrate flow, test on a measured strip and confirm volumes by refill counts. For variable-rate, import prescription maps from DJI Terra/SmartFarm or your agronomy platform.

Yes. Generate NDVI/NDRE and zone maps (e.g., DJI Terra/SmartFarm or third-party GIS) and import prescriptions to drive variable-rate spraying or spreading (workflow/file-format dependent).

Flush with clean water after each job (especially after crystallising or sticky products). Clean sprinklers, filters and lines; check seals, clamps and hoses; store the system drained. Follow DJI service intervals.

Operate within the manual’s wind and weather limits; avoid heavy rain. Keep electronics dry, protect batteries from heat/moisture, and clean hopper/spinner and intakes frequently when spreading in dusty environments.

One pilot can fly; productivity improves with a second person handling refills, batteries and the field station. Larger jobs benefit from a dedicated bowser driver or ground support.

Yes, routes can be shared across Agras models with parameter checks (tank size, speed, swath). Validate each task and run a short test pass before full application.

Yes, with the correct approvals. Spraying must comply with HSE/CRD rules and typically requires appropriate PA certification. Flights with an Agras fall in the Specific category, so you’ll usually need a GVC and a CAA Operational Authorisation (often via a SORA-based safety case), plus compliant insurance.

Set height, speed and droplet size correctly and downwash helps drive droplets into the canopy without flattening plants. Avoid excessive heights/speeds and follow label guidance to reduce drift.

Different tools for different jobs: drones excel in wet or inaccessible ground and can target patches with minimal compaction. With proper setup, RTK lines and verified rates, consistency is high. Keep logs, maps and totals for audit trails.

Follow product labels and HSE guidance. Use appropriate pesticide PPE when mixing/loading and cleaning. Work from a level, cordoned-off staging area, respect drift buffers and watercourses, and carry spill kits.

UK onboarding, setup and training, plus spares, repairs and technical support. We also advise on chargers, batteries, bowsers and documentation for CAA/HSE compliance.

Agriculture drone price varies by configuration (spraying only vs. spreading kit, Fly More bundles, extra batteries/charger). Contact us for current DJI Agras pricing, on-farm demos and tailored quotes.

Yes — finance and leasing options are available to UK farms and contractors (subject to status). We can structure bundles around your season and workload.